Banks Power Chevy_GMC Trucks: Duramax LMM (Diesel ’07 - 10 6.6L) Power Systems- PowerPack & Stinger w_EconoMind '07-10 (iQ) Compatible with Optional Banks iQ User Manual
Page 39
96818 v.2.0
39
Remove the fuse access panel shown
in Figure 26. Remove the lower
knee bolster panel by removing the
2 Phillips screws on the lower edge
of the panel. Using a 10mm socket
and ratchet, unbolt the brake release
lever. Pull the panel out by grasping it
on either side of the steering column
and pull out as shown in Figure 35.
Disconnect any switch wires.
5.
Cut out the supplied template,
Template 3 in the back of the
manual, and align the template to the
right edge of the IP to the left of the
steering column. Tape the template in
place. A 90° drill will be needed to drill
the hole. Continue to Step 7.
6.
To install Switch as shown in
Figures 31 & 32:
Follow Step 4 to remove the IP for
both Dash styles. Cut out the supplied
template, Template 4 in the back of
the manual, and align the template
onto the rear of the knee bolster,
squarely seating it into the panel
corner as shown in Figure 36.
7.
Using a
3
⁄
8
” Uni-bit step drill bit or
a
3
⁄
8
” drill bit, center the bit onto the
3
⁄
8
” drill location on the template and
slowly drill through the IP. Using a
1
⁄
8
”
drill bit, center and drill through the
1
⁄
8
” location on the template. Remove
and discard the template and any
plastic shavings.
8.
On the front side of where the
Switch will be mounted, clean the
area with some alcohol and allow it
to dry. Remove the backing from the
EconoMind Label and align it over the
previously drilled hole.
9.
Remove the nut and internal tooth
washer from the EconoMind Switch.
Rotate the shaft counter clockwise
until the shaft stops. Verify the locating
washer tab is inserted into the #6
position on the Switch (Figure 37).
Figure 35