Banks Power Chevy_GMC Trucks: Duramax LLY-LBZ (Diesel ’06 - 07 6.6L) Speed Control- Banks Brake w_ Switch User Manual
Page 10
10
97246 v.3.0
5.
Secure the wire harness using
some of the supplied cable ties along
the factory wire harness up the left
side of the engine to the Fuse box.
6.
Remove the Driver side cowl
support Brace and retain hardware for
reuse. See Figure 3.
7.
Remove the fuse box cover to
access the fuses on the electrical
center and set aside.
8.
Remove the fuse box assembly
cover by expanding the fuse box out
towards the engine side and lifting up,
exposing the fuse electrical center.
See Figure 4.
9.
Push out on the tab closest to the
fender and the two locking tabs on the
side of the electrical center and lift up
to gain access to the c100 connector.
Disconnect the c100 connector. See
Figure 5.
10.
Install the ground ring terminal
on the Banks Brake wire harness onto
the bolt on the bottom of the electrical
center closest to the fire wall. See
Figure 5.
11.
Insert the male c100 connector
on the Banks Brake wire harness to
the female C100 factory connector.
Insert the female c100 connector on
the Banks Brake wire harness to the
male C100 factory connector.
12.
Position the electrical center back
in place until the tabs snap into place.
Note: adjust the C100 connection
under the electrical center to have
sufficient room to lock the electrical
center back in place. Run the wire
harness out to the firewall side of the
fuse brace. See Figure 6.
13.
Locate mini-fuse for the Body
control Module (TBc IGN1) and remove
it. See Figure 7.
Figure 5