Banks Power Chevy_GMC Trucks: Duramax LLY-LBZ (Diesel ’06 - 07 6.6L) Speed Control- Banks Brake w_ Switch User Manual
Page 8
8
97246 v.3.0
Note: If you have purchased a
combination Banks Brake/ tuner
Package, install the tuner First and
ignore the installation of the oBD
II interface cable. After completing
installation of the tuner continue with
this manual.
1.
Disconnect the negative (ground)
cable from the battery (or batteries, if
there are two) before beginning work.
Secure the cables so that they do not
come in contact with the battery posts
during the installation.
2.
Locate the Banks Brake wire
harness in your kit. Start By placing
the wire harness near the under hood
fuse box. Run the Main transmission
intercepting connector wire harness
on the Banks Brake wire harness
down to the transmission following the
factory transmission main connector
harness from the transmission control
module.
3.
On the right side of the
transmission locate the transmission
main connector. See Figure 2.
Disconnect the connector by applying
pressure on both sides and pull out.
4.
Insert the female connector on the
Banks Brake wire harness into the
transmission connector. Insert the
factory main transmission connector
to the male connector on the Banks
Brake wire harness.
Note: When installing the male
connector to the transmission orient
the arrow on the connector up.
Figure 2 Factory Main transmission Connector Location