Banks Power Chevy_GMC Trucks: Duramax LLY-LBZ (Diesel ’06 - 07 6.6L) Speed Control- Banks Brake w_ Switch User Manual
Page 16
16
97246 v.3.0
WARNING: Make sure to place the
Banks Brake Module as shown in
Figure 11 to avoid a clearance issue
when closing the hood. Mount the
SpeedBrake Module as close to the
inside edge of the fuse cover as
possible.
22.
Insert the Banks Brake 20-pin
female connector on the wire Harness
to the Banks Brake Module. Using the
supplied cable ties, secure the wire
harness away from any heat sources
(i.e. Driver side exhaust manifold) or
moving components.
23.
Reinstall the driver side cowl
support brace. Tighten the factory
hardware to 80 in-lbs.
24.
Locate the Banks OBD II Interface
Cable in your kit. This cable has
three connection points. Connect the
RED OBD II connector on the Banks
interface cable to the vehicle OBD II
connector. Use a cable tie as shown
in Figure 14 to secure the Banks
interface cable to the vehicle OBD II
connector.
25.
Next, connect the 6-pin connector
on the Banks OBD II interface cable
to the 6-pin connector on the Banks
Brake wire harness routed through the
firewall.
26.
The RJ12 connector (phone like
connector) on the Banks Brake Wire
harness will be connected in the next
section to the Brake level selector
switch. Leave this wire loose for
connecting to Brake level switch.
27.
Go over all connection. Secure
the wire harness with the supplied ties
under the dash.
WARNING: Take care to keep any
cables away from the pedals
or where they could become
tangled.
-END, SECTION 1-
Figure 14