Banks Power Chevy_GMC Trucks: Duramax LLY-LBZ (Diesel ’06 - 07 6.6L) Speed Control- Banks Brake w_ Switch User Manual
Page 19
97246 v.3.0
19
6.
After confirming the locating
washer is in the #5 location, install
the switch through the
3
⁄
8
” hole on the
backside of the instrument panel. The
alignment pin should rest in the
1
⁄
8
”
hole and with the switch fully rotated
counter clockwise; the shaft’s flat side
should be facing the steering column.
Secure switch with internal tooth
washer and nut. Snug the washer; be
careful not to over torque the nut and
damage the plastic threads.
7.
Install the knob onto the shaft
facing the Off Level on the Banks
Brake label. On the knob, snug the two
(2) set screws with the supplied 0.050”
hex key wrench.
8.
Route the RJ12 connector
(phone like connector) to the Banks
Brake switch cable connector, and
plug the connectors together.
9.
Reinstall the IP panel, make all
electrical connections that were
disconnected. Secure all loose wiring
under the dash with supplied cable
ties.
WARNING: Take care to keep any
cables away from the pedals
or where they could become
tangled.
10.
Reinstall the lower knee panel
back in place with the factory
hardware. Tuck any excess cable
behind it for a clean appearance.
-END, SECTION 2-
Figure 18