Banks Power Chevy_GMC Trucks: Duramax LLY-LBZ (Diesel ’06 - 07 6.6L) Speed Control- Banks Brake w_ Switch User Manual
Page 13
97246 v.3.0
13
Figure 9
If a Banks Diesel Tuner has been
previously installed, skip step 20.
19.
Locate the rubber grommet on
the driver’s side of the vehicle firewall.
The grommet is about 3” in diameter.
Make a 1” x 1” cross-shaped incision
in the grommet. See Figure 10.
Now from inside the cab locate the
grommet on the firewall and make
another 1” x 1” cross-shaped incision
on the grommet.
20.
Locate the In cab cable on Banks
Brake wire harness and feed the single
connector cable through the incision
made in the firewall grommet and into
the cab.
21.
With the Banks Brake Module
positioned on top of the fuse box, peel
the protective backing from the hook
and loop interlocking fasteners and
attached to the Brake Module. Position
the Brake module to the edge closest
to the engine of the fuse cover then
press the adhesive onto the outside
of the fuse box cover. Apply light
pressure to the Brake Module by hand
for 60-seconds to create a strong bond
between the fuse box and hook & loop
interlocking fasteners.
Note: make sure the fuse box cover
is clean and free of any oil residue and
contaminates. Clean fuse box cover
with a non-oil based solvent such as
Acetone, Mineral Spirits, Denatured
Alcohol or Lacquer thinner. Read and
follow the manufactures operation
instruction for non-oil based solvent
cleanser.
If vehicle is equipped with a Banks
tuner, detach the tuner from the top
of the fuse box cover and reattach on
the fuse box side or on top of the fuse
box along with the Banks Brake. See
Figure 12 & 13. If placing the tuner
on top of the fuse box along with the
Brake module there may be some
over hang from the tuner. Secure the
tuner so that it stays in place. Use
the supplied hook & loop interlocking
fasteners to make the necessary
adjustment to attach the Banks Brake
to the top of the fuse box cover and
Banks tuner to the fuse box side or
top.