Banks Power Chevy_GMC Trucks: Duramax LLY-LBZ (Diesel ’06 - 07 6.6L) Speed Control- Banks Brake w_ Switch User Manual
Page 11
97246 v.3.0
11
14.
Install the mini-blade fuse tap
onto the removed mini fuse as shown
in Figure 8. Re-install the mini fuse
with the attached blade tap into the
fuse box.
Note: install the fuse tap in the
Body Control Module (tBC IGN1) spot
closest to the firewall. this is the “hot”
side of the circuit. See Figure 7.
15.
Locate the fuse connector wire
on the Banks Brake wiring harness and
connect it to the mini-blade fuse tap.
Replace the fuse box assembly cover
and make sure not to pinch the fuse
connector wire.
16.
Replace the fuse box cover.
17.
Locate the black wire harness
locking connectors between the brake
fluid reservoir and the air conditioning
compressor. Lift the gray connector
locks and disconnect the 24-pin
connector pair. See Figure 9.
18.
Insert the male 24 pin connector
on the Banks Brake harness into the
female 24-pin connector on the factory
harness. Insert the female 24-pin
connector on the Banks Brake harness
onto the male 24-pin connector of the
factory harness.
Note: If vehicle is equipped with a
Banks tuner, disconnect the 24-pin
connection between the factory 24-pin
connectors and the Banks tuner
24-pin connectors. It is not important
if the intercepting connection is made
before the Banks tuner connection
or after. this will not affect the
performance of the Banks tuner or
Banks Brake. Insert the male 24 pin
connector on the Banks Brake harness
into the female 24-pin connector on
the factory harness or Banks tuner’s
harness. Insert the female 24-pin
connector on the Banks Brake harness
onto the male 24-pin connector of
the factory harness or Banks tuner’s
harness.
Figure 6