Banks Power Chevy_GMC Trucks: Duramax LLY-LBZ (Diesel ’06 - 07 6.6L) Speed Control- Banks Brake w_ Switch - Manual (Page 22)

22
97246 v.3.0
Flash
Code
PDA Error Message Corrective Action- LBZ/ LMM
1.1 Code 11: VGT control input
out of range
Turn ignition OFF and check the 24-Pin connector.
Turn ignition back ON and re-check for presence of
code.
1.2 Code 12: Vane Position
Sensor input out of range.
Turn ignition OFF and check the 24-Pin connector.
Turn ignition back ON and re-check for presence of
code.
1.3 code 13: Rear wheels
slipping
None required. When traction is regained, error will
clear after 30 seconds.
1.4 Code 14: Low power
voltage detected.
Turn ignition OFF and check the Fuse Tap and the
Ground O-ring. Turn ignition back ON and re-check for
presence of code.
2.1 Code 21: VGT control
output malfunction.
Turn ignition OFF and check the 24-Pin connector.
Turn ignition back ON and re-check for presence of
code.
2.2 Code 22: VGT control
output overcurrent.
Turn ignition OFF and check the 24-Pin connector.
Turn ignition back ON and re-check for presence of
code.
2.3 Code 23: Low relay voltage
detected.
Turn ignition OFF. Turn ignition back ON and re-check
for presence of code.
2.4 Code 24: Vane Position
Sensor voltage output
malfunction.
Turn ignition OFF and check the 24-Pin connector.
Turn ignition back ON and re-check for presence of
code.
3.1 code 31: OBD
communication error.
Turn ignition off and check the OBD connector
and cable. Turn ignition back ON and re-check for
presence of code.
3.2 code 32: Internal module
malfunction or intermittent
power.
Turn ignition OFF. Turn ignition back ON and re-check
for presence of code.
3.3 code 33: OBDII cAN
communication output
error.
Turn ignition OFF and check the 16-Pin c100
Intercepting connector. Turn ignition back ON and re-
check for presence of code.
3.4 code 34: OBDII cAN
communication input error.
Turn ignition OFF and check the 16-Pin c100
Intercepting connector. Turn ignition back ON and re-
check for presence of code.
4.2 code 42: Torque converter
Clutch slippage detected.
Turn ignition OFF and check the 16-Pin c100
Intercepting connector. Turn ignition back ON and re-
check for presence of code.
4.3 code 43: Shift control
malfunction.
Turn ignition OFF and check the 16-Pin c100
Intercepting and 20-Pin connectors. Turn ignition back
ON and re-check for presence of code.
4.4 Code 44: Internal memory
malfunction.
Turn ignition OFF. Turn ignition back ON and re-check
for presence of code.
If problem persists, call Gale Banks Engineering Tech Support.
Table 1 - (For 06-08 model years)