Grain Systems PNEG-1472 - Manual (Page 9)

3. Safety Decals
PNEG-1472 L & B Series Field Installation 9
WARNING
Automatically controlled
belt drive can start at
anytime. Keep hands
clear. Failure to do so
could result in serious
injury.
DC-971
DANGER!
Automatic equipment can
start at any time. Do not
enter until fuel is shut off
and electrical power is
locked in off position.
Failure to do so will result
in serious injury or death.
DC-973
Decal DC-974 has several different locations. Two are located on the
front end panel below the fan/heater. Two are located on the rear end
panel below the rear access door. Two are located on the auger
discharge box (one on the outside top and one on the inside of the
flapper lid next to the discharge mercury switch). One more of these
decals is located inside the plenum on the rear plenum closure door just
inside the rear access door.
Decal DC-971 is located on the bottom auger belt guard and the front
bearing plate (which is visible when then bottom auger belt guard is
removed). An alternate location would be at the rear of the dryer for
portable dryers equipped with the Front Discharge Option.
Another location for decal DC-971 is the top auger belt guard
(one on the belt guard cover and one inside on the belt guard body visible
when the belt guard cover is remove).
Decal DC-1227 is located on the
fan/heater access door.
Decal DC-973 is located on the rear plenum access door
(inside and outside).