Grain Systems PNEG-1283 - Manual (Page 12)

4. Installation
12 PNEG-1283 Moisture Sampler
19. To install the Moisture Sampler drive belt, loop the belt over one of the sheaves and the stretch it
over the other one. Belt direction is marked with an arrow on belt. If necessary remove any belt
links. After the belt is installed the sheave on the auger shaft can be adjusted forward or back for
proper belt alignment. The slot in the end plate can be used to tension the belt. When everything is
aligned tighten the auger shaft sheave and any other hardware left loose.
Figure 4I
20. Install the belt guard using four (4) 3/8" bolts (S-7927) and nuts (S-968).
Figure 4J
Bolt locations for belt guard
4 ea. 3/8"-16 x 1" bolt (S-7927)
4 ea. 3/8"-16 nut (S-968)