Grain Systems PNEG-1283 - Manual (Page 7)

PNEG-1283 Moisture Sampler 7
4. Installation
Installation Instructions for Dryers Made before September 2002
Figure 4A
1. Remove the auger bearing shield. (See Figure 4A.)
2. Remove the lock collar from the auger shaft. (See Figure 4B.) To remove the lock collar loosen the
set screw and then locate the dimpled hole on the side of the lock collar. Using a hammer and
punch, set the punch in the dimpled hole and hit it in a clockwise direction until the lock collar is
freed from the bearing.
Figure 4B
Auger tube Auger bearing shield Discharge switch conduit
Unload auger bearing plate Standard grain sampler Discharge side panel Discharge box bearing plate
Lock collar
Set screw