Flashing support at stiffeners, Chapter 10 flashing support at stiffeners – Grain Systems Bin Flooring PNEG-529 User Manual
Page 25
PNEG-529 Cor-Lok and Cut-Lok Flooring for Non-GSI Bin Diameter
25
10. Flashing Support at Stiffeners
Stiffener Flashing Support Instructions for Internal
Universal Stiffeners
1. Install the floor and support system, cutting the floor to go around the internal stiffeners as required.
2. Break the stiffener flashing support (SS-6984) into its three (3) components.
3. Lay the flashing supports on top of the flooring and weld the flashing supports to the stiffener as close
as possible. Fasten the flashing to the wall, flashing support and floor. Seal all spaces by welding
or caulking.
4. Paint all welds with good quality zinc rich paint.
5. Stiffener flashing supports (SS-6984) must be ordered separately from the standard floor
and flashing.
Figure 10A