Grain Systems Tanks PNEG-1092 - Manual (Page 36)

36 PNEG-1092 30° Bin Roof Construction
8. Support Ring Instructions
Ring Instructions
Be sure to install ladder rungs and safety steps as you assemble roof panels. (See Figure 8A.) At this
point you will have completed assembly of the roof. Do not tighten bolts yet. Optional equipment and
accessories should now be installed.
NOTE: When assembling such pieces as roof ladder rungs, use 5/16" x 1-1/4" bolts with a flat washer on
top of the slot and extra neoprene washer between the roof and the piece being added. This will
ensure a more protective seal against moisture.
IMPORTANT: Maximum weight to be supported and/or suspended from the roof is to be 6000 pounds
for 12' through 48' (non-trussed) ONLY.
IMPORTANT: Maximum weight to be supported and/or suspended from the roof is 10000 lbs. for
commercial (trussed roof) 39'-60' flattop roof bins. Roof loads should be supported from
the flattop or at the second lower “Z” collar.
Figure 8A
WARNING
DO NOT OVERFILL BIN. Stored grain, although heaped in the center, should
be no higher than the roof eaves at the outer edge. Filling the bin above this
point creates excessive internal pressure and may cause swelling and eventual
failure of the roof.