Grain Systems Tanks PNEG-1000 - Manual (Page 30)

30 PNEG-1000 2.66" Commercial Tank Stiffener and Sidewall
8. Installation
Base Angle Installation
On the lower edge of the final bottom ring, attach the base angle ring utilizing 5/16" x 1-1/4" bin bolts.
Before the bolts are tightened, push the angle tight against the bottom edge of the sheet. Before
lowering the bin, apply the optional mastic sealer to the entire underneath side of the base angle.
(See Figure 8A.) Next, lower the bin onto the foundation and check for an adequate seal. If base sealer
strip is not used some other method should be utilized to seal the base ring to the concrete.
NOTE: Inside stiffened shown.
Figure 8A
Ref # Description
A 5/16" x 1-1/4" Bin Bolt
B Base Angle (B-6753)
C Mastic Sealer (Optional)
D Outside
E Inside