Grain Systems Unload Augers PNEG-1057 - Manual (Page 17)

8" Vertical Assembly
9
PNEG 1057 - 8" & 10" Commercial Vertical Bin Unloading Auger
G. Position motor mount straps (15) and clips (14) and secure to rod (26) using four 3/8" x 3" long carriage bolts
with nuts. Leave only finger tight until motor is installed and adjusted.
H. Attach belt guard (17) to belt guard mounting angles (27) using four 5/16" x 3/4" carriage bolts with flat washers
and nuts.
I. Slide bearing lock collar (4) over head stub shaft (13). Leave enough stub exposed to mount
pulley (18) on stub with drive key (37). Tighten bearing lock collar next to bearing and tighten set screws
in pulley.
J. Install pulley on head stub shaft and mount motor on strap (15). (Motor and pulley not furnished.) Install
belts (2) and align pulleys. Tighten motor to straps (15). Adjust motors along the tube and tighten with 3/8" x 3"
carriage bolts.
K. After everything has been adjusted correctly, go back and tighten all nuts and bolts.
23
3
13
40
22
27
24
14
26
25
15
15
26
14
24
27
28
4
17
2
17
18
37