Grain Systems Bucket Elevtors, Conveyors, Series II Sweeps PNEG-1807 - Manual (Page 69)

10. 4 x 5 Distributor Platform (Optional)
PNEG-1807 16"-24" Bucket Elevator Platform and Ladder “X” Series 69
Assemble Supports (16"-24")
1. Attach brace channels to the sides of the support channels using four (4) 1/2" x 1" bolts and nuts.
Angle the knee braces across the bottom sides of the brace channels and attach using four (4)
1/2" x 1" bolts and nuts.
2. Assemble the cross supports to the bottom side of the support channels using the end and middle
sets of holes on the support channels using four (4) 1/2" x 1" bolts and nuts. (See Figure 10E.)
3. Assemble the external platform support (DSP1648EPS) to the end of the three (3) cross supports
using six (6) 1/2" x 1" bolts and nuts. (See Figure 10F on Page 70.)
NOTE: For 24" installation the lower knee brace will use the second hole on the brace and the second
hole up from the bottom on the brace channel. (See Figure 10G on Page 70.)
Figure 10E Distributor Platform Cross Support