Grain Systems Unload Augers PNEG-1050 - Manual (Page 26)

26 12" & 14" Commercial Bin Sweep Augers PNEG-1050
Assembly
6. END WHEEL ASSEMBLY
(Refer to Fig. 15.)
(6) Sweep Shield
(2) Sweep Flight
(1) Stub
(3) End Wheel
(4) Collar
(5) Bearing Stand Weldment
1. Install stub (1) into sweep flight (2) using a 5/8" x 4"
long hex head capscrew and 5/8" nylon lock nut.
2. Slide bearing stand weldment (5) over stub (1) and bolt
it to the sweep shield (6) using a 3/8" x 3" hex head
capscrew, a 3/8" x 3" long carriage bolt and a
FIG. 15
flatwasher, lockwasher and non-lock nut. Use the
carriage bolt in the slotted hole of the bearing stand (5).
3. Slide end wheel (3) and collar (4) onto the stub (1). Bolt
the collar (4) in place with a 1/2 "x 3-1/4" long hex head
capscrew and 1/2" nylon lock nut.