Grain Systems Unload Augers PNEG-1050 - Manual (Page 27)

27 12" & 14" Commercial Bin Sweep Augers PNEG-1050
Assembly
7. SWEEP TRACTOR TO BACK SHIELD ASSEMBLY
(Refer to Fig. 16.)
1. Mount the sweep tractor (1) to the last shield section
(2) furthest from the drive end. There are six 7/16"
holes that have been pre-punched in the shield. Bolt
sweep tractor (1) to shield (2) using six 3/8" x 1" hex head capscrews with flat washers and nylon locknuts.
2. Adjust bracket on sweep tractors as needed to get the
correct angle and height to match sweep.
Completed Tractor Assembly
FIG. 16
Sweep Shield
Adjustment bolts for adjusting the
angle and height of the bracket
(3/8" x 1" HHCS with flat
washer’s Nylon Locknut)