Grain Systems PNEG-1458 - Manual (Page 26)

6. Vision Touch Screen Display
26 PNEG-1458 T-Series Tower Dryer
Figure 6C
To setup a timer touch the button of the timer you wish to modify. The Modify Timer Set Point screen
will then be displayed.
(See Figure 6C.) Note that there are two (2) number pads on this Modify screen.
The left number pad is used to modify the minutes and the right number pad will modify the seconds.
Touching the Default button will automatically set the timer to the default set point for that timer. The
Accept button will save the timer set point displayed in the time display. Touching Cancel will exit the
Modify Timer Set Point screen without saving any changes and the timer will stay at the currently
saved set point.
Once you have the timer set points set touching the Exit button at the bottom of the Modify Timer
Set Point screen will return you to the Operation screen.
Setting the Temperatures
Setting the plenum temperature set point for the dryer is a simple procedure. To adjust the plenum
temperature touch the
button at the bottom of Operation screen. A new screen will appear called
the Select Temperature Set Point to Modify screen. (See Figure 6D on Page 27.)
Operation screen for setting timers
Modifying timer set point