Grain Systems PNEG-1877 - Manual (Page 14)

Chapter 2 Ladders
Ladder Section Assembly
1. Attach two (2) splice plates (LDR-4317) to the ends of both ladder sections, connecting them
together.
2. Fasten with 5/16" x 3/4" bolts. The head of the bolt should be to the inside of the ladder with the
splice plate on the outside.
NOTE: Wind rings must be installed in relation to the ladder rungs leaving a minium of 1–1/2” below a
ladder rung and 4–1/2” above a ladder rung.
Figure 2-2 Ladder Section Assembly
14 Pneg-1877 Top Dry Ladders, Safety Cage, and Platforms