Grain Systems PNEG-1877 - Manual (Page 30)

Chapter 5 Safety Cage Assembly
Intermediate Safety Cage Hoop Assembly
1. Use 5/16" x 3/4" bolt with the head of the bolts to the inside of the safety cage.
2. Attach the safety cage hoop brackets to the ladder section.
3. Take the safety cage hoop adjuster plates and bolt them onto the extension angle.
4. Bolt the safety cage hoop adapters and safety cage hoop halves together using the proper holes
depending on the diameter of the grain bin.
5. Bolt these assemblies to the safety cage hoop brackets and safety cage hoop adjuster plates, tighten
bolts as you go.
6. The bottom assembly requires two (2) hoop halves and will be positioned just below the platform.
7. Use the safety cage hoop adjuster angle to secure the two (2) hoop half assembly to the vertical
entrance angle on the platform assembly.
30 Pneg-1877 Top Dry Ladders, Safety Cage, and Platforms