Installation – Grain Systems Tanks PNEG-2135 User Manual
Page 69
Advertising
10. 2.66" Commercial Tank Accessories Installation
PNEG-2135 Construction Manual for 2.66" Corrugation 135' Diameter Tank
69
Installation
7. If the roof sheet does not have a pre-punched hole for the roof vent, a hole must be cut. Cut the hole
to match the roof vent. The inside edge of the hole should be approximately 15" from the eave.
8. Place the three (3) foam strips on roof sheet, as shown in
. Position roof vent over foam
strips and bolt down using 5/16" x 3/4" bin bolts and nuts. NOTE:
for lower two (2)
bolts of vent.
Figure 10E
Figure 10F
Figure 10G
Advertising