Installing a rear module, Installing a rear module (p. 2-3), Installation and setup – Cobalt Digital COMPASS 9374-EMDE Quad-Stream SDI – AES – MADI Embedder_De-embedder User Manual
Page 25
937X-OM (V1.3)
9374-SERIES PRODUCT MANUAL
2-3
Installation and Setup
Installing a Rear Module
Note:
If installing a card in a frame already equipped for, and connected to
DashBoard™, no network setup is required for the card. The card will be dis-
covered by DashBoard™ and be ready for use.
Installing a Rear Module
Notes: • This procedure is applicable only if a Rear Module is not currently
installed in the slot where the 9374-Series Card is to be installed.
• Note that some Rear Modules and labels have several ventilation holes. To
allow maximum ventilation, it is recommended to place the label fully over
connectors such that label is flush with rear module and holes are not
obscured. Also, when a card is not installed in a slot, it is recommended that
the supplied blank cover be used to preserve proper forced ventilation
flow-through.
The full assortment of 9374-Series Card Rear Modules is shown and
described in 9374-Series Card Rear Modules (p. 2-4). Install a Rear Module
as follows:
1.
On the frame, determine the slot in which the 9374-Series Card is to be
installed.
2.
In the mounting area corresponding to the slot location, install
Rear Module as shown in Figure 2-1.