Cobalt Digital COMPASS 9374-EMDE Quad-Stream SDI – AES – MADI Embedder_De-embedder - Manual (Page 26)

2
Installing a Rear Module
2-4 9374-SERIES PRODUCT MANUAL 937X-OM (V1.3)
Figure 2-1 Rear Module Installation
9374-Series Card Rear Modules
Table 2-1 shows and describes the full assortment of Rear Modules
specifically for use with the 9374-Series cards.
Note: The Rear Modules shown here are standard production items. Other signal
combinations may be available as custom items. Consult Product Support
with requests. Also, please check our web site pages for this product; new
Rear Modules may be available that are not listed here.
DSCN3483A.JPG
Align and engage mounting tab on Rear
I/O Module with the module seating slot
on rear of frame chassis.
Hold top of Rear Module flush against
frame chassis and start the captive screw.
Lightly tighten captive screw.
DSCN3487A.JPG
1
2