Cobalt Digital COMPASS 9033 Input Processing Analog to Digital Video - Manual (Page 20)

1
9033 Functional Description
1-16 9033 PRODUCT MANUAL 9033-OM (V4.0)
9033 Rear I/O Modules
The 9033 physically interfaces to system video and audio connections using a
Rear I/O Module. Figure 1-8 shows a typical 9033 Rear I/O Module.
All inputs and outputs shown in the 9033 Functional Block Diagram (Figure
1-1) enter and exit the card via the card edge backplane connector. The
Rear I/O Module breaks out the 9033 card edge connections to industry
standard connections that interface with other components and systems in the
signal chain.
In this manner, the particular inputs and outputs required for a particular
application can be accommodated using a Rear I/O Module that best suits the
requirements. The required input and outputs are broken out to the industry
standard connectors on the Rear I/O Module; the unused inputs and outputs
remain unterminated and not available for use.
The full assortment of 9033 Rear I/O Modules is shown and described in
9033 Rear I/O Modules (p. 2-6) in Chapter 2, “Installation and Setup”.
Figure 1-8 Typical 9033 Rear I/O Module
Audio and Video Formats Supported by the 9033
The 9033 supports all current SMPTE standard SD and HD video formats.
Table 1-1 lists and provides details regarding the audio and video formats
supported by the 9033.
BNC connectors for
coaxial video and
AES audio signals
In this example, an RM-9033-F Rear I/O
Module provides a connection interface
for the signal types shown here.
Phoenix terminal
block connectors for
3-wire and 2-wire
terminations