Cobalt Digital COMPASS 9033 Input Processing Analog to Digital Video - Manual (Page 32)

2
Installing the 9033 Into a Frame Slot
2-4 9033 PRODUCT MANUAL 9033-OM (V4.0)
9. Repeat steps 1 through 8 for other 9033 cards.
Note: The 9033 BNC inputs are internally 75-ohm terminated. It is not necessary to
terminate unused BNC inputs or outputs.
Note: To remove a card, press down on the ejector tab to unseat the card from the
rear I/O module mating connector. Evenly draw the card from its slot.
10. If network remote control is to be used for the frame and the frame has
not yet been set up for remote control, perform setup in accordance with
Cobalt
® reference guide “COMPASS™ Remote Control User Guide”
(PN 9000RCS-RM).
Note: If installing a card in a frame already equipped for, and connected to
DashBoard™, no network setup is required for the card. The card will be dis-
covered by DashBoard™ and be ready for use.