Cobalt Digital COMPASS 9391 3G_HD_SD-SDI Timecode Burn-In Inserter - Manual (Page 21)

9391-TCB-OM (V1.3) 9391-TCB PRODUCT MANUAL 2-3
Installation and Setup
Installing a Rear Module
Note: If installing a card in a frame already equipped for, and connected to
DashBoard™, no network setup is required for the card. The card will be dis-
covered by DashBoard™ and be ready for use.
Installing a Rear Module
Notes: • This procedure is applicable only if a Rear Module is not currently
installed in the slot where the 9391 is to be installed.
• Note that some Rear Modules and labels have several ventilation holes. To
allow maximum ventilation, it is recommended to place the label fully over
connectors such that label is flush with rear module and holes are not
obscured. Also, when a card is not installed in a slot, it is recommended that
the supplied blank cover be used to preserve proper forced ventilation
flow-through.
9391 Rear Modules are shown and described in 9391 Rear Modules (p. 2-4).
Install a Rear Module as follows:
1. On the frame, determine the slot in which the 9391 is to be installed.
2. In the mounting area corresponding to the slot location, install
Rear Module as shown in Figure 2-1.
Figure 2-1 Rear Module Installation
DSCN3483A.JPG
Align and engage mounting tab on Rear
I/O Module with the module seating slot
on rear of frame chassis.
Hold top of Rear Module flush against
frame chassis and start the captive screw.
Lightly tighten captive screw.
DSCN3487A.JPG
1
2