Rainbow Electronics GE863-GPS low power - Manual (Page 110)

GE863-GPS Software User Guide
1vv0300724 Rev. 3 - 05/07/07
Reproduction forbidden w ithout Telit Communications S.p.A. w ritten authorization - All Rights Reserved page 110 of 122
5.6.4 GPS PARAMETERS SAVE
This command allows saving the set parameters in the module’s memory
Syntax of the command :
AT$GPSSAV
After this command restart the module to update the modifications.
5.6.5 RESTORE GPS PARAMETERS
This command allows restoring the factory default parameters for the GPS module
Syntax of the command :
AT$GPSRST
After this command restart the module to update the modifications.
5.6.6 READ ACQUIRED GPS POSITION
This command allows reading the acquired position of the GPS receiver
Syntax of the command :
AT$GPSACP
The response sintax is:
$GPSACP:<UTC>,<latitude>,<longitude>,<hdop>,<altitude>,<fix>,<cog>,
<spkm>,<spkn>,<date>,<nsat>
The fields contain the following information:
<UTC>:
(referred to GGA sentence)
hhmmss UTC of Position
Values:
hh (hour) 00 to 23
mm (minutes) 00 to 59
ss (seconds) 00 to 59
<latitude>: (referred to GGA sentence)
ddmm.mmmm N/S Values:
dd (degrees) 00 to 90
mm.mmmm (minutes) 00,0000 to 59.9999
N/S: North / South