Rainbow Electronics GE863-GPS low power - Manual (Page 30)

GE863-GPS Software User Guide
1vv0300724 Rev. 3 - 05/07/07
Reproduction forbidden w ithout Telit Communications S.p.A. w ritten authorization - All Rights Reserved page 30 of 122
For example:
1- Let's assume you have to call the national number 040 - 4192111,
command:
ATD 0404192111<cr>
response
CONNECT 9600
2- Let's assume you have to call the national number but in international format +39-40-4192111,
command:
ATD +39404192111<cr>
response
CONNECT 9600
3- Let's assume you have to call the international number +386-40-4192111,
command:
ATD +386404192111<cr>
response
CONNECT 9600
2.7.3 Closing the Data call
2.7.3.1 Exit the data mode and enter the command mode
•
Send escape sequence
+++
•
wait the escape sequence pause time ( see S12 parameter)
•
wait for response
OK
NOTE: After the Escape sequence and during the call the only command that is accepted by
the GE863-GPS is the ATH. All the other commands are not supported during a call.
TIP: during the escape sequence pause time S12 no further characters should be sent to the
device in order to enter the command mode.