3 restricting calling line indication, 1 set caller line id indication presentation, At+clip=<n><cr – Rainbow Electronics GE863-GPS low power User Manual

Page 45

Advertising
background image





GE863-GPS Software User Guide

1vv0300724 Rev. 3 - 05/07/07

Reproduction forbidden w ithout Telit Communications S.p.A. w ritten authorization - All Rights Reserved

page 45 of 122

3.2.2.1 Set Caller line ID indication presentation

Send command

AT+CLIP=<n><cr>


where:
<n> is the operation mode selected:

0 – Calling Line Indication Presentation Disabled
1 – Calling Line Indication Presentation Enabled

wait for

OK

response

For example:
1- Let's assume you receive a call from the national number 1234567890 and extended incoming calls
indication is disabled while CLIP is enabled, you'll see:
ring indication:
RING

+CLIP: "1234567890",129


2- Let's assume you receive a call from the international number +391234567890 and extended
incoming calls indication is disabled while CLIP is enabled, you'll see:
ring indication:
RING

+CLIP: "+391234567890",145

NOTE: this does not mean that the incoming call is an international one, it simply means that the
numbering scheme used to identify the caller is the international one.

3.2.3 Restricting Calling Line Indication

The GE863-GPS is able to send the calling line indication (CLI) to the other party through the network
when an outgoing call is made. This indication can be restricted (CLIR) in various ways:

CLI sent always

CLI never sent

CLI temporary sent (normally not sent)

CLI temporary not sent (normally sent)

Advertising