3 hardware unconditional shutdown – Rainbow Electronics GE863-GPS low power User Manual
Page 14
GE863-GPS Software User Guide
1vv0300724 Rev. 3 - 05/07/07
Reproduction forbidden w ithout Telit Communications S.p.A. w ritten authorization - All Rights Reserved
page 14 of 122
2.4.1.3 Hardware Unconditional SHUTDOWN
To unconditionally SHUTDOWN the GE863-GPS the pin RESET# must be tied low for at least 200
milliseconds and then released.
A simple circuit to do it is:
NOTE: don't use any pull up resistor on the RESET# line nor any totem pole digital output.
Using pull up resistor may bring to latch up problems on the GE863-GPS power regulator and
improper functioning of the module. The line RESET# must be connected only in open
collector configuration.
TIP: The unconditional hardware RESET should be always implemented on the boards and
software should use it as an emergency exit procedure.
RESET#
Unconditional Power OFF
impulse
GND