Rainbow Electronics GE863-GPS low power - Manual (Page 117)

GE863-GPS Software User Guide
1vv0300724 Rev. 3 - 05/07/07
Reproduction forbidden w ithout Telit Communications S.p.A. w ritten authorization - All Rights Reserved page 117 of 122
5.7.4 Message 105 – Development Data On/Off
Use this command to enable development data information if you are having trouble getting
commands accepted. Invalid commands generate debug information that enables you to determine
the source of the command rejection. Common reasons for input command rejection are invalid
checksum or parameter out of specified range.
The command has the following syntax:
$PSRF105,<Debug>< checksum><CR><LF>
Examples:
1. Debug On
$PSRF105,1*3E
2. Debug Off
$PSRF105,0*3F
The following table describes the command fields:
Name Example Unit Description
Message ID $PSRF105 PSRF105 protocol header
Debug 1 0=off, 1=On
Checksum *3E
<CR><LF> End of message termination