Rainbow Electronics GE863-GPS low power - Manual (Page 44)

GE863-GPS Software User Guide
1vv0300724 Rev. 3 - 05/07/07
Reproduction forbidden w ithout Telit Communications S.p.A. w ritten authorization - All Rights Reserved page 44 of 122
3.2.1.1 Set the extended incoming call indication
•
Send command AT+CRC=<n><cr>
where:
<n> is the operation mode selected:
0 – extended results Disabled (device reports RING only)
1 – extended results Enabled (device reports +CRING: <type> indication)
•
wait for
OK
response
3.2.2 Identify the Caller
The GE863-GPS is able to identify the caller number and give indication of it before the call is
answered.
The calling number is presented after each RING or +CRING indication in the format:
+CLIP: "<number>",<type>[,"<subaddress>",<satype>[,"<alpha>"[,<CLI validity>]]]
OK
where:
<Number> is the phone number;
<type> is the type of number:
145 – international numbering scheme
129 – national numbering scheme
<subaddress> is the subaddress of the calling party
<satype> is the type of subaddress
<alpha> is an optional string type alphanumeric representation of <number> corresponding to
the entry found in phonebook;
<CLI validity> is the validity status of CLI presentation:
0 CLI valid.
1 CLI has been withheld by the originator.
2 CLI is not available due to interworking problems or limitation or originating network.
In order to use this feature you must enable the caller ID indication presentation, if feature is disabled
then no CLI indication is given after the RING or +CRING code.