Peerless-AV IWB600-UNIV - Installation - Manual (Page 15)

15 of 18 ISSUED: 11-09-10 SHEET #: 125-9158-4 12-21-10
Installing to Marsh Boards
Hook top vertical supports ( A) onto exposed M5 x 8 mm phillips screw on top depth adjusting bracket (D).
Secure using two M5 x 8 mm phillips screws ( J) in extended position as show in detail 7.
4
Fasten two support brackets (supplied with Marsh Board) to vertical supports ( B) using four M5 x 12 mm phillips
screws ( O) and M5 serrated flanged lock nuts (N) as shown below.
NOTE: Make sure that the distance between the top of the support bracket and bottom of hole is 1/8".
NOTE: Use only the large bottom four mounting holes on vertical support (B).
5
1/8"
support brackets
(supplied with
Marsh Board)
support brackets
(supplied with
Marsh Board)
A
D
J
Exposed M5 x 8 mm
phillips screw
O
N
Top Support Bracket
(supplied with ActivBoard)
Bottom Support Bracket
(supplied with ActivBoard)
USE LARGE
BOTTOM HOLES
DETAIL 7
Rest Marsh Board face down on a non abrasive surface to prevent scratching.