Peerless-AV IWB600-UNIV - Installation - Manual (Page 3)

3 of 18 ISSUED: 11-09-10 SHEET #: 125-9158-4 12-21-10
Fasten one M5 x 8 mm phillips screw ( J) into front hole in top depth adjusting bracket (D) leaving 1/8” of exposed
thread.
NOTE: Make sure flange of top depth adjusting bracket (D) is located on bottom as shown in figure 1.1.
Be sure top depth adjusting brackets ( D) are level and in desired position. Then use top depth adjusting bracket (D)
as a template to mark center of two mounting holes. Drill two mounting holes. Attach top depth adjusting bracket
( D) to mounting surface using two screws provided by installer and two 1/4 washers (I) if required.
NOTE: Top and bottom vertical support assemblies (A and B) may be used to determine location of
top depth adjusting bracket ( D).
1
• Installer must verify that the supporting surface will safely support the combined load of the equipment and all
attached hardware and components.
WARNING
Secure bottom depth adjusting bracket ( F) to
bottom vertical support ( B) using two
M5 x 8 mm phillips screws ( J) in extended position.
2
Loosely fasten support bracket ( C) to bottom
vertical support ( B) with two #10-32 x 1/2" socket
screws ( G) using 4 mm allen wrench (S) as
shown below.
Repeat using second bottom vertical support ( B).
3
J
D
D
I
Screws provided by installer
MOUNTING SURFACE
B
B
J
C
G
F
FLANGE
FIGURE 1.1
FIGURE 1.2