Peerless-AV IWB600-UNIV - Installation - Manual (Page 9)

9 of 18 ISSUED: 11-09-10 SHEET #: 125-9158-4 12-21-10
Determine Top Depth Adjusting Bracket Position
Determine Top Depth Adjusting Bracket Position
NOTE: Top and bottom vertical support assemblies (A and B) may be used to determine height of
top depth adjusting bracket ( D).
Fasten one M5 x 8 mm phillips screw ( J) into front hole in top depth adjusting bracket (D)
leaving 1/8” of exposed thread as shown in figure 3.1.
Position top depth adjusting brackets ( D) using dimension determined in step 2 and mark center of two mounting
holes. Drill two mounting holes. Attach top depth adjusting bracket ( D) to mounting surface using two screws
provided by installer and two 1/4 washers ( I) if required.
3
• Installer must verify that the supporting surface will safely support the combined load of the equipment and all
attached hardware and components.
WARNING
J
D
D
I
Screws provided by installer
MOUNTING SURFACE
Mounting Top Depth Adjusting Bracket
FIGURE 3.1 FIGURE 3.2
2
Attach bottom depth adjusting bracket ( F) to bottom
vertical support ( B) using two M5 x 8 mm phillips
screws ( J) in extended position.
Repeat with second bottom depth adjusting
brackets.
J
F
DEDICATED MOUNTING