Airbagit Air Management - Manual (Page 11)

9
To Save a Preset
Presets should only be set after the height sensors have been calibrated.
1. Raise or Lower each corner to the desired position.
2. Press the center of the Smart-Ride Button once and then the press the
right side of the Smart-Ride button “>” button to enter into the Preset Setup Screen #1.
3. Press whichever preset button you would like to have associated with the current position. The control-
ler will beep once and save the current position.
4. Press the Smart-Ride Button once to exit out of the setup screens.
To Activate a Preset
1. Press the button once for the desired preset. The heights and pressure associated with that preset will
flash on the LCD.
2. Double press the preset button quickly to activate the preset. The button lights will flash and if the button
beeper is turned on it will beep while the system is going towards the preset.
Compressor Functionality
1. The Smart-Ride will send out a +12V signal when the Tank Pressure is outside the range set in Setup
Screen #2.
2. The compressor can be set to run whenever the tank is low or whenever the tank is low and the LCD is
turned on. (See Setup Screen #2 section)
2. The Smart-Ride is only capable of suppling 40amps of current to run a compressor. Any compressors
requiring more than 40A will require a relay to be installed between the Smart-Ride and the compressor.
NOTE: UNLESS YOUR RELAY CAME WITH A BUILT IN DIODE,
THEN A DIODE NEEDS TO BE INSTALLED.
3. The Compressor will run for only 5 mins at a time and then turn off.
This will prevent the compressor from running if there is a leak or a failed airline.
The COMP light will turn red when this error has occured. In the regular control screen
Press the “D” button to restart the compressor.
Restore Factory Defaults
1. Press the center of the Smart-Ride Button once and then the press the right side of the Smart-Ride
button “>” button to enter into the Preset Setup Screen #1.
2. Press and hold the “D” button for 3 seconds.
85 86
30
87A
87
GROUND YELLOW
COMP WIRE
NOTE: IF YOUR RELAY
DOES NOT HAVE THIS
SYMBOL
THEN A DIODE MUST BE
ADDED