Airbagit Smart Ride - Manual (Page 10)

A I R B A G I T. C O M S U S P E N S I O N S
2 6 0 S . H I B B E R T, M E S A , A Z P H . 8 0 0 - 8 4 2 - 8 7 8 9
Smart Ride
COMPLETE DIGITAL AIR MANAGEMENT SYSTEM
9
A I R B A G I T. C O M S U S P E N S I O N S
2 6 0 S . H I B B E R T, M E S A , A Z P H . 8 0 0 - 8 4 2 - 8 7 8 9
Smart Ride
COMPLETE DIGITAL AIR MANAGEMENT SYSTEM
PRESE Ts SE TUP and tips PRESE Ts setup and tips
To Save a Preset
Presets should only be set after the height sensors have been calibrated.
1. Raise or Lower each corner to the desired position.
2. Press the center of the Smart-Ride Button once and then the press the right side of the Smart-Ride
button “>” button to enter into the Preset Setup Screen #1.
3. Press whichever preset button you would like to have associated with the current position. The control-
ler will beep once and save the current position.
4. Press the Smart-Ride Button once to exit out of the setup screens.
To Activate a Preset
1. Press the button once for the desired preset. The heights and pressure associated with that preset will
flash on the LCD.
2. Double press the preset button quickly to activate the preset. The button lights will flash and if the button
beeper is turned on it will beep while the system is going towards the preset.
Compressor Functionality
1. The Smart-Ride will send out a +12V signal when the Tank Pressure is outside the range set in Setup
Screen #2.
2. The Smart-Ride is only capable of suppling 40amps of current to run a compressor. Any compressors
requiring more than 40A will require a relay to be installed between the Smart-Ride and the compressor.
3. The Compressor will run for only 5 mins at a time and then turn off. This will prevent the compressor
from running if there is a leak or a failed airline. The COMP light will turn red when this error has occured.
Press the “D” button to restart the compressor.
Functionality Tips
1. The Smart-Ride will attempt to move the vehicle to the requested preset for 30 seconds. After this time
the system will cancel the function. If the vehicle hasn’t reached its desired preset before this 30 seconds
then the flow control valves need to be adjusted to increase or decrease the speed.
2. Pressing any key while the system is moving the vehicle towards a preset will cancel the function.
3. Adjusting the timing and flow control valves will allow the vehicle to lift and lower at the same speed.
4. The Height and Pressure Tolerance settings should not be set tighter than the movement of the vehicle
in 1 pulse. To verify this, enable the “Pulse on Manual Control” option that is described in the Setup Screen
#2 page. Once this is enabled, press the “D” button to start the compressor. Let the compressor run until it
shuts off at its set Tank High Pressure. Next, press each “Manual Control Button” and read the movement
displayed on the LCD in the height section or pressure section. The amount of movement found must be
less than the tolerance setting.
For Example: If one pulse moves the Rear Right from 4.2 to 5.1 than the Height Tolerance shouldn’t be
any smaller than 0.9.