Ironwood Electronics 0.8mm Pitch SMT Foot And Female-to-Female Socket Attachment And Use - Manual

Cross section: A-A Target PCB
Daughter board
UGA socket
Surface mount Foot
A
Top View: Surface mount foot
Orientation mark, Align with Target pin A1
Surface mount Foot
© 2001 IRONWOOD ELECTRONICS, INC.
Tele: (800) 404-0204
www.ironwoodelectronics.com
Filename: DUI.mcd, Rev A, I Pal, 4/4/01
0.8mm Pitch SMT foot and female-to-female socket
Attachment and Use
Step 1 Attach SMT BGA emulator foot to target PCB
A) Attach the surface mount foot such that the orientation mark aligns with pin A1 on the target PCB.
(see the 'BGA Surface Mount Emulator Foot Soldering Instructions' document for details)
Step 2 Plugging socket onto SMT foot
A) Align surface mount foot and UGA socket as shown above (Note: orientation of pin A1).
B) Plug the socket onto the SMT foot evenly with a gentle rocking action.
Step 4 Unplugging socket from SMT foot
A) Pull the upper assembly off the SMT foot by applying and even force to all corners of the upper assemblys' daughter board. For
large pin count adapters, a slight rocking motion can be used to ease the separation of the two parts. A properly soldered BGA
foot will withstand the forces encountered when inserting and extracting the top assembly.