Factory Direct Hardware Hansgrohe 10402001 Axor Starck X - Manual (Page 2)

2
Starck Tub Filler
10402XX1
Technical Specification
Maximum incoming water pressure 145 psi
Recommended water pressure 14.5 - 72 psi
Recommended max. incoming hot water temp. 120 o F - 140 o F*
Flow rate of tub filler @ 45 psi 5.75 gpm
Flow rate of handshower 2.5 gpm
Backflow prevention furnished by check valve in the handspray outlet and automatically
closing diverter
Installation Considerations
• This unit requires 2 1/2" female fittings, located 5 7/8" apart on center (+/- 5/8"),
recessed 3/8" behind the surface of the finished wall.
• This unit is not anti-scald. If anti-scald is required by local plumbing code, or is
desired, install this unit with a remote pressure balance valve, such as Hansgrohe
13418181 or similar unit.