Factory Direct Hardware Hansgrohe 10402001 Axor Starck X - Manual (Page 5)

5
• Remove the handle screw. Pull the
green high temperature limit stop
straight off the cartridge.
• Reinstall the high temperature limit stop
so that the positioning pin on the
cartridge is in the hole for the desired
high temperature. The temperatures
shown on the diagram assume an
incoming cold water temperature of
50 o F and an incoming hot water
temperature of 140 o F.
• Test the unit. Reposition the high
temperature limit stop again if required.
• Reinstall the nut cover. Reinstall the
handle screw and tighten four complete
turns. Reinstall the handle and continue
tightening the screw. Reinstall the screw
cover.
1 Handle 10490XXX
1.1 Screw cover 96338000
2 Flange 96395000
3 Nut 96461000
4 Cartridge 92730000
5 Flange 96467000
6 S-connector
7 Diverter 94077000
8 Diverter knob 96466XXX
9 Check valve 94074000
10 noise reducer 96429000
11 hose 28282XXX
12 screen washer
13 handshower 28531XXX
14 spray former 97467000
XXX = color
000 = chrome
1
2
3
4
5
6
7
8
9
10
11
12
13
14
1.1
Replacement Parts