Factory Direct Hardware Toto TEL3LW10#CP - Manual (Page 5)

5
ENGLISH
Install the Controller (continued)
3. Mount the water inlet bracket(s) on the wall,
using wall anchors (not included) if necessary and
temporarily tighten the screws. Hold the controller in
place on the bracket(s) to check for any obstructions
that may interfere with the controller or connections.
Once the bracket position is confirmed, tighten the
mounting screws (see Ill. 3).
NO TE: For the thermal mixing controllers, the water
inlet brackets MUST be mounted 3-¾” (95mm)
apart (center to center) to allow for proper
connection to the controller.
IMPORTANT!
Be sure to mount each water inlet bracket in the
correct upright direction as shown. Otherwise, the
strainer on the water inlet bracket will be inaccessible
for cleaning.
4. Connect the hot/cold water supply lines to the water
inlet bracket(s). For the thermal mixing controllers,
ensure that the hot water supply is connected to the
left water inlet bracket (see Ill. 4).
5. Connect the controller to the water inlet bracket:
For Single Supply Controller: Push the controller into
the water inlet bracket until it is fully seated, and
secure it with the included quick fastner.
For Thermal Mixing Controller: Check that the rubber
gaskets are located in the water inlet brackets.
Hold the controller in place and tighten the nuts
on the inlet brackets to secure it.
IN
COLD IN
OUT
HOT IN
OUT
Ill. 3 Wall Anchors
(not included)
Wall Anchors
(not included)
Water
Inlet
Bracket
Self-Tapping Screw
Self-Tapping Screw
3-3/4”
(95mm)
Water
Inlet
Bracket
THERMAL MIXING
MODELS
SINGLE SUPPLY
MODELS
Water Inlet
Bracket -
Side View
Water Inlet
Bracket -
Side View
Flexible Hose
(not included)
Flexible Hose
(not included)
Nut
Nut
Nut
Gasket
Gasket
Gasket
Water Inlet
Bracket
Water Inlet
Bracket
Copper Tube
(not included)
Nut
Friction Ring
Cone Washer
Controller
Controller
Quick Fastener
Ill. 4 SINGLE SUPPLY MODELS
THERMAL MIXING MODELS
(Copper tube may be used in place of flexible hose)
Spout
gasket
Flex hose
Faucet Hole
1-3/8” (35mm)
gasket
Mounting
nut
Mounting
Bracket
Lock
Washer
III. 1
adapter
Supply Stop
3/8”
compression nut
strainer
min. 1-3/8”
(35mm)
To install Integrated Deck Mount Models (III.1):
NOTE: 1-3/8” (35mm) faucet hole and 1-3/8” (35mm) min.
gap between finished wall and back of the spout is highly
recommended so that an Allen wrench can be placed behind
the spout (see the image below) for service/maintenance.
1. Install the spout with gasket into the center hole in deck
or lavatory.
2. Install strainers and flex hoses onto HOT and COLD
supply stops.
3. Tighten the 3/8” compression nuts to supply stops first;
then place the strainers and tighten the adapters.
4. Tighten the flex hoses securely to the adapters.
Set Screw
Allen wrench
Top Cover