Factory Direct Hardware Toto ABA990X#01FCP - Manual (Page 35)

35
(2) Fill-tub operation
➀ Close the drain valve in the bathtub and set the On/Off button on the controller to ON.
➁ Set to ON.
➂ Confirm that the fill-tub cascade is flowing out of the fill-tub outlet.
➃ Confirm that there are no leaks in the plumbing.
➄ Wait until the fill-tub feature finishes normally.
When the tub has been filled, a melody will play and then stop automatically.
(3) Air blower
❈ Please make sure that there is hot water in the tub after running the fill-tub feature.
➀ Set the On/Off button on the controller to ON.
➁ Set to ON.
➂ Confirm that there is air flowing out of the nozzles in the bottom of the bathtub.
➃ Confirm that there are no air or water leaks in the plumbing.
➄ Set to OFF.
(4) Shoulder warmer
❈ Please make sure that there is hot water in the tub after running the fill-tub feature.
➀ Set the On/Off button on the controller to ON.
➁ Set to ON.
➂ Confirm that there is water flowing out of the (two) shoulder warmer outlets.
➃ Confirm that there are no leaks in the plumbing.
➄ Set to OFF.
(5) Underwater illumination
➀ Set the On/Off button on the controller to ON.
➁ Set to ON.
➂ Confirm that the (two) lighting modules are turned on.
➃ Confirm that there are no leaks in the lighting modules.
➄ Set to OFF.