SCANTECH ID (Champtek company) SIRIUS S-7030 - Manual (Page 16)

10
2.1 CONNECTING THE SCANNER
Installation
Before you connect any cable to the scanner, decide whether you will guide it
backward as a tail or downward, through the foot and counter surface!
1. Remove the end cover.
Firmly press the end cover as indicated below and carefully slide the cover
approx. ¾ cm. downward (referring to normal operating position).
Now you can lift off the cover.
(If you have an older type of cover, press the two little clips on the bottom
and carefully shift the end cover downward and take it away. („Downward‟ is
referring to the normal lower side of the scanner, if positioned in operating
position.))
2. Make sure the power has been turned off and connect the interface cable
to the 10-pin RJ-48 connector of the scanner as indicated below:
3. In case you use an EAS cable do not forget to mount the EAS connector
on the small white port under the data port.