SCANTECH ID (Champtek company) SIRIUS S-7030 - Manual (Page 29)

Using the Sirius S-7030
3.3 SINGLE LINE SCANNING
The Sirius is provided with a “Single Line” option, which helps you selecting
23
specific codes when multiple bar codes are very close together. A typical case
is when you need to scan just one code from a pick list
full of bar codes.
Instructions for Single Line scanning:
1. Take the scanner in your hand and press the
button.
The scan pattern will change to a single line now.
2. Aim the single line on the barcode to be scanned
while holding the button pressed.
3. Once the scan line is completely crossing the barcode, release the button.
At this moment, the code is read, a beep sounds and the data is
transmitted.
The scan line will blink as a confirmation of good read and as a warning that
the single line mode will stop unless you press the button again!
4. If you press the button again during the blinking period, you can start
scanning another barcode using single line.
ATTENTION
If you need to scan many barcodes sequentially, in Single Line
mode, you can best press the button again directly after releasing
it. In this way you reenter the Single Line mode immediately.
This will protect you from the following risk:
IMPORTANT
If you release the button and keep the scanner aimed at a group of
barcodes, the scanner will return to normal, omni-directional
operation, as soon as the blinking period of the line stops.
Barcodes in range of the omni-directional scan field will be read,
even without pressing the button!