SCANTECH ID (Champtek company) SIRIUS S-7030 - Manual (Page 20)

14
5. Optional:
Lead the cables from the bottom upwards
through the hole in the counter, through the
bottom plate and through the scanner stand.
Click the stand on the bottom plate.
Installation
6. Connect the cable(s) to the scanner. Refer to chapter 2.1 for the correct
method.
7. Place the scanner onto the flexible stand and rotate the scanner into the
desired position.
8. Connect the data cable to the host.
See note in Chapter 2.2
9. If applicable, connect the power supply plug to the power injector. Than
connect the IEC power cord to the AC/DC power supply and plug the AC
power cord into an AC power outlet.
10. Place the scanner in the desired angle (see Chapter 3.1).
11. Switch on the host system
ATTENTION
Once the scanner is installed, you can start scanning bar code
labels. If you want to change the default settings of the scanner,
proceed to the Configuration Guide which came with the scanner.