Asus TS700-E7/RS8 - Manual (Page 47)

TS700-E7/RS8 2-27
Chapter 2
Connectors Description
SGPIO1 Connects to SATA SGPIO1 connector on the motherboard
SGPIO2 Connects to SAS PSGPIO1 connector on the motherboard
SGPIO3 Connects to SAS PSGPIO2 connector on the motherboard
BPSMB1
Connects to Front panel SMB connector on the
motherboard
U1 Connects to 4-pin plug of the power supply
CON1/CON2/
CON3/CON4
Connects to SATA/SAS connectors on the motherboard
Move the SGPIO_SEL1 jumper on the SATA/SAS backplane to 2–3 when
installing the PIKE RAID card.
2.9 Removable components
You may need to remove previously installed system components when installing
or removing system devices, or when you need to replace defective components.
This section tells how to remove the following components:
1. System fans (front and rear)
2. Chassis footpads
3. Redundant power supply module
2.9.1 System fan
Removing the front system fan
To remove the front system fan:
1. Remove the two screws that secure
the right side cover.
1
1