Asus TS700-E7/RS8 - Manual (Page 91)

TS700-E7/RS8 5-21
Chapter 5
5.4.4 PCH SATA Configuration
SATA Mode [AHCI Mode]
Allows you to set the SATA configuration.
Configuration options: [Disabled] [IDE Mode] [AHCI Mode] [RAID Mode]
• If you want to use the Serial ATA hard disk drives as Parallel ATA physical
storage devices, set this item to [IDE Mode].
• If you want the Serial ATA hard disk drives to use the Advanced Host If you want the Serial ATA hard disk drives to use the Advanced Host
Controller Interface (AHCI), keep the default setting [AHCI Mode]. The
AHCI allows the onboard storage driver to enable advanced Serial ATA
features that increases storage performance on random workloads by
allowing the drive to internally optimize the order of commands.
• If you want to create RAID sets with LSI MegaRAID utility, or Intel If you want to create RAID sets with LSI MegaRAID utility, or Intel ® Rapid
Storage Technology Enterprise from the Serial ATA hard disk drives, set this
item to [RAID Mode].
(1)IDE Mode. (2)AHCI
Mode.(3)RAID Mode.
SATA Port1 Not Present
SATA Port2 ASUS DWR ATAPI
SATA Port3 WDC WD800JD(80.0GB)
SATA Port4 Not Present
SATA Port5 Not Present
SATA Port6 Not Present
SATA Mode [AHCI Mode]
SATA Controller 1 [Enhanced]
SATA Controller 2 [Enhanced]
S.M.A.R.T. Status Check [Enabled]
Port 1 Staggered Spin-up [Disabled]
Port 2 Staggered Spin-up [Disabled]
Port 3 Staggered Spin-up [Disabled]
Port 4 Staggered Spin-up [Disabled]
Port 5 Staggered Spin-up [Disabled]
Port 6 Staggered Spin-up [Disabled]
Version 2.15.1219. Copyright (C) 2011 American Megatrends, Inc.
→←
: Select Screen
↑↓
: Select Item
Enter: Select Item
+/-: Change Opt.
F1: General Help
F2: Previous Values
F5: Optimized Defaults
F10: Save & Exit
ESC: Exit
Aptio Setup Utility - Copyright (C) 2011 American Megatrends, Inc.
Advanced