Asus ESC500 G2 - Manual (Page 83)

ASUS ESC500 G2 4-15
DRAM Voltage [Auto]
Allows you to set the DRAM voltage. The values range from 1.20V to 2.20V with a
0.01V interval.
According to Intel CPU spec, DIMMs with voltage requirement over 1.5V may
damage the CPU permanently. We recommend you install the DIMMs with the
voltage requirement below 1.5V.
VCCIO Voltage [Auto]
Allows you to set the VCCIO voltage. The values range from 0.90V to 1.70V with a
0.01V interval.
VCCSA Voltage [Auto]
Allows you to set the VCCSA voltage. The values range from 0.77V to 1.60V with a
0.01V interval.
CPU PLL Voltage [Auto]
Allows you to set the CPU PLL voltage. The values range from 1.20V to 2.20V with
a 0.01V interval.
Load-Line Calibration [Auto]
Load-line is defined by Intel VRM spec and affects CPU voltage. The CPU working
voltage will decrease proportionally to CPU loading. Higher load-line calibration
would get higher voltage and better overclocking performance, but increase the
CPU and VRM thermal. Configuration options: [Auto] [Disabled] [Enabled]
The actual performance boost may vary depending on your CPU specification.
CPU Spread Spectrum [Auto]
[Auto] Automatic configuration.
[Disabled] Enhances the BCLK overclocking ability.
[Enabled] Sets to [Enabled] for EMI control.