Xylem 19 001 351R2 PACE Integrated Pump Controller Human Machine Interface (HMI) for the Silent Storm VFD Pumping System – User Guide - Manual (Page 15)

15
Figure 29: Setup Menu, Supervisor
USER SETUP
Tap [User Setup] from the setup menu.
This menu allows a supervisor to set the date/time,
language, colors, and units. A lamp test to check all
lamps on the control panel may also be performed.
Figure 30: User Setup Menu, Guest
NOTE: The [Set Language/Colors] and [Set Units]
menu selections are not currently available.
Set/Sync HMI-PLC Date/Time
Tap [Set/Sync HMI-PLC Date/Time] from the User
Setup menu.
This screen allows the date and time to be set, and
synchronized for the PLC and HMI. Tap
[Synchronize] to synchronize HMI & PLC date and
time.
In a new pop up screen, enter the date and time.
Tap [Set Date/Time – Close] to save changes. Tap
[Clear Totalizers] to clear all totalizers.
Note that when the HMI time is set, the HMI will
automatically sync the PLC time once/day.
CAUTION:
Synchronization should not be done while
using the Internet-based remote client as this
has the potential to negatively affect the time
settings of the system. Syncing should only be
performed locally.
Figure 31: Set/Sync HMI-PLC Date/Time
Lamp Test
Tap [Lamp Test] from the User Setup menu.
Holding this button for 3 seconds causes all lights
on the control panel to light up briefly. Any bulb that
does not light up should be replaced.
LOCKOUT SETUP
Tap [Lockout Setup] from the Setup Menu.
Lockout setup is similar in appearance to the
Lockout View accessible in the Operation menu.
Individual lockouts may be setup by tapping over
each lockout inset. Tapping any inset opens a
configuration window. The day, start time, and
duration may be entered in the interval tab at the
top. In the parameter tab, the combo number,
setpoint, and speed can be entered. Tap [Apply] to
save settings or [Close] to discard any changes.
An individual lockout setup screen is shown below.